Under the brand BARK is rowing and motor boats, inflatable PVC, all boats are made from BARK boat from PVC and VALMEX HEYTEX (Germany). Handcrafted ensures quality and reliability.
Boats BARK, favorably reliability, versatility, aesthetic appeal and excellent seagoing qualities.
Inflatable Boats BARK belong to the class, and pleasure boats are designed for recreation, hunting, fishing, tourism, and use as an auxiliary boat or aboard ships. BARK is constantly working to improve the design and improvement of reliability of inflatable boats made in this regard, the delivery is subject to change.

BARK hard to overturn the boat, but a reasonable distribution of the load in the boat will not be superfluous. Do not leave everything on one side and distribute the load evenly inside the boat. Inflatable PVC Boat BARK is designed so that when damaged one air chamber (cylinder) boat remains afloat at the expense of other cylinders and you safely reach the nearest shore, even on a damaged boat. In the event of damage to the boat, going down to pull up the camera, holding as high as possible above the water.
The valve has two boats of the moving part:
- Put forward by the moving part - the valve in operation (mode of filling the boat with air cover);
- The movable part is sunk - the valve open state (mode bleed air out of the bay boats).
To switch the valve from one position to another press - with his finger on the movable portion and the crank 90 degrees in either direction until it locks.

- To prevent excessive pressure in the cylinders boats;
- To remove sand and dirt from the surface of the boat after the operation;
- In contact with gasoline or oil on the surface of the boat thoroughly rinse the area with;
- Post-season boat wash and dry. Store at 0-25 ° C;
- Repair (removal of a puncture, cut container or bottom) can be performed alone or consult your dealer.

To bring the boat in working condition:
- Deploy a boat in a clean place;
- Insert the deck into the pockets on the bottom of the boat;
- Fill the air, stern and bow sections to a pressure of 150 MPa;
- Close the valve caps;
- Set the seat;
- Insert a paddle in the stern of the boat to paddle
It is strictly forbidden:
- Operate without a boat and personal rescue equipment;
- Overloading the boat is higher than the carrying capacity;
- Adjust the pressure in the tank boat to a value exceeding the nominal;
- Use engine capacity exceeding the maximum allowable for a particular model boats;
Data on maximum engine power for boats BARK listed on the label on the stern of the boat and in the manual.
To ensure the reliability necessary to use a boat equipment and accessories only as intended.
BARK ensures availability of boats subject to the rules for handling and storage contained in the manual.
The warranty period of inflatable boats made of PVC brand BARK - 36 months.
The warranty does not cover:
- On the boat's operating manual;
- On a boat with no defects of an industrial nature, arising out of violations of the rules for handling and storage;
- Additional equipment for the boats.
Boats BARK - reliable companion!